Multi-Port Antennas

CCI Portal Login

CCI Customer Portal

In the Americas
   
 
 
 
Sales  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Customer Service  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Technical Support  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
 

      Multi-Band Fourteen Port Antenna FPA65R-BU4D
                
       
       
         
  PI FPA65RBU4D ISO FRONT PI FPA65RBU4D ISO REAR  
  • Four foot (1.2 m) internally multiplexed MultiBand, fourteen port antenna, with a 65° azimuth beamwidth covering 698-896 MHz and 1695-2400 MHz frequencies
  • Eight wide mid band ports covering 1695-2400 MHz, two wide low band ports covering 698-896 MHz and four frequency specific low band ports covering 717-728 MHz and 758-798 MHz (over distributed diplexing) in a single antenna enclosure
  • Innovative Low and Mid Band Array configuration allows for independent 2T2R (2x2 MIMO) on B29 Low Band Array and 4T4R (4x4 MIMO) on B14/B12 Low Band Arrays and Dual 4T4R (4x4 MIMO) Mid Band Array, using full length arrays, all in a 20.7” (525 mm) width enclosure
  • Industry leading antenna topology and RET shielding techniques drastically mitigate PIM propagation from B12/B14/B29 operations, allowing for superior Network performance
  • Full Spectrum Compliance for 698-896 MHz / 1695-2400 MHz operations
  • LTE Optimized FBR and SPR performance, providing for an efficient use of valuable radio capacity
  • LTE Optimized Boresight and Sector XPD and USL performance, essential for LTE Performance
  • Exceeds minimum PIM performance requirements
  • Internally Integrated RET Controllers (Type 17)
  • Equipped with new 4.3-10 connector, which is 40% smaller than traditional 7/16 DIN connector

Overview

 

The CCI internally multiplexed MultiBand array is a fourteen port antenna, with eight wide mid band ports covering 1695-2400 MHz, two wide low band ports covering 698-896 MHz and four frequency specific low band ports covering 717-728 MHz and 758-798 MHz (over distributed diplexing).

The antenna provides the capability to deploy 4T4R (4x4 MIMO) in the Mid Band, with a separate RET control. The antenna also provides the capability to provide independent RET control for B29 and B14/B12 operations.

CCI antennas are designed and produced to ISO 9001:2008 certification standards for reliability and quality in our state-of-the-art manufacturing facilities.

Applications

 
  • Dual 4×4 MIMO for the Mid band ports and 2x2 MIMO on B29 ports and 4x4 MIMO on B14/B12 ports
  • Ready for Network Standardization on 4.3-10 connectors
  • With CCI’s multiband antennas, wireless providers can connect multiple platforms to a single antenna, reducing tower load, lease expense, deployment time and installation costs

Electrical

         
Ports 2 × Low Band Ports for 717-728 MHz 2 × Low Band Ports for 758-798 MHz 2 × Low Band Ports for 698-896 MHz
Frequency Range 717-728 MHz 758-798 MHz 698-806 MHz 824-896 MHz
Gain1 11.7 dBi 12.6 dBi 13.1 dBi 13.1 dBi
Gain (Average)2 11.5 dBi 12.0 dBi 12.2 dBi 12.7 dBi
Azimuth Beamwidth (-3dB) 78° 74° 72° 66°
Elevation Beamwidth (-3dB) 20.4° 19.4° 20.2° 18.0°
Electrical Downtilt 2° to 16° 2° to 16 2° to 16°° 2° to 16°
Elevation Sidelobes (1st Upper) < -13 dB < -13 dB < -17 dB < -16 dB
Front-to-Back Ratio @180° > 27 dB > 30 dB > 34 dB > 35 dB
Front-to-Back Ratio ±20° > 26 dB > 29 dB > 29 dB > 32 dB
Cross-Polar Discrimination at Peak > 25 dB > 25 dB > 25 dB > 25 dB
Cross-Polar Discrimination at Sector2 4.9 dB 5.3 dB 9.0 dB 4.5 dB
Cross-Polar Port-to-Port Isolation > 25 dB > 25 dB > 25 dB > 25 dB
Voltage Standing Wave Ratio (VSWR) < 1.5:1 < 1.5:1 < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -153 dBc ≤ -153 dBc ≤ -153 dBc ≤ -153 dBc
Input Power Continuous Wave (CW) 500 watts 500 watts 500 watts 500 watts
Polarization Dual Linear 45° Dual Linear 45° Dual Linear 45° Dual Linear 45°
Input Impedance 50 ohms 50 ohms 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground DC Ground DC Ground
1Peak gain across sub-bands.
2Electrical specifications follow document "Recommendation on Base Station Antenna Standards" (BASTA) V11.1.
         
Ports 8 × Mid Band Ports for 1695-2400 MHz
Frequency Range 1695-1880 MHz 1850-1990 MHz 1920-2180 MHz 2300-2400 MHz
Gain1 16.6 dBi 16.8 dBi 17.2 dBi 17.3 dBi
Gain (Average)2 15.3 dBi 15.8 dBi 16.1 dBi 16.3 dBi
Azimuth Beamwith (-3dB) 70° 67° 67° 61°
Elevation Beamwidth (-3dB) 8.4° 7.4° 6.9° 5.9°
Electrical Downtilt 2° to 10° 2° to 10° 2° to 10° 2° to 10°
Elevation Sidelobes (1st Upper) < -15 dB < -14 dB < -14 dB < -14 dB
Front-to-Back Ratio @180° > 35 dB > 35 dB > 35 dB > 35 dB
Front-to-Back Ratio ±20° > 32 dB > 32 dB > 32 dB > 32 dB
Cross-Polar Discrimination at Peak > 21 dB > 19 dB > 20 dB > 24 dB
Cross-Polar Discrimination at Sector2 7.3 dB 4.4 dB 5.5 dB 5.8 dB
Cross-Polar Port-to-Port Isolation > 25 dB > 25 dB > 25 dB > 25 dB
Voltage Standing Wave Ratio (VSWR) < 1.5:1 < 1.5:1 < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -153 dBc ≤ -153 dBc ≤ -153 dBc ≤ -153 dBc
Input Power Continuous Wave (CW) 300 watts 300 watts 300 watts 300 watts
Polarization Dual Linear 45° Dual Linear 45° Dual Linear 45° Dual Linear 45°
Input Impedance 50 ohms 50 ohms 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground DC Ground DC Ground
1Peak gain across sub-bands.
2Electrical specifications follow document "Recommendation on Base Station Antenna Standards" (BASTA) V11.1.

Mechanical

Dimensions (L×W×D) 48.0×20.7×9.7 in (1220×525×247 mm)
Survival Wind Speed > 150 mph (> 241 kph)
Front Wind Load1 138 lbf @ 100 mph    613 N @ 161 kph
Side Wind Load1 45 lbf @ 100 mph     202 N @ 161 kph
Effective Projective Area (EPA), Front1 5.5 ft2 (0.5 m2)
Weight* 64.2 lbs (29.1 kg)
Connector 14 × 4.3-10 female
Mounting Pole 2 to 5 in (5 to 12 cm)
1Windload values calculated using CFD analysis
* Weight  excludes mounting kit

Bottom View FPA65R-BU4DB 
  PI FPA65RBU4DB BOTTOM

Connector Spacing FPA65R-BU4DB (Type 17 Internal RET)
  PI FPA65RBU4D Connector Spacing

RET to Element Configuration FPA65R-BU4DB Element and RET configuration (Type 17 Internal RET)
  PI FPA65RBU4DB RET Element Diag

Typical Antenna Patterns

  For detailed information on additional antenna patterns, contact customer support at
  PI FPA65RBU4D AP 722 AZEL9 PI FPA65RBU4D AP 788 AZEL9
  722 MHz Azimuth with Elevation 9° (Ports 1, 2, 5 & 6) 788 MHz Azimuth with Elevation 9° (Ports 1, 2, 3 & 4)

  PI FPA65RBU4D AP 896 AZEL9  
  896 MHz Azimuth with Elevation 9° (Ports 1 & 2)  

  PI FPA65RBU4D AP 1755 AZEL6 PI FPA65RBU4D AP 2155 AZEL6
  1755 MHz Azimuth with Elevation 6° (Ports 7 to 14) 2155 MHz Azimuth with Elevation 6° (Ports 7 to 14)

  PI FPA65RBU4D AP 2360 AZEL6  
  2360 MHz Azimuth with Elevation 6° (Ports 7 to 14)  
MBK-02   MBK-02 Mounting Kit with with 0° to 10° mechanical tilt adjustment
MBK-15   MBK-15 Mounting Kit with fixed 0° mechanical tilt
BSA-RET400   Type 17 Internal Remote Electrical Tilt System (RET)
AISGC-M-F-10FT   10 Foot (3 M) Male/Female AISG cable for Type 17 RET
SCU-AISG-P   Portable AISG 2.0 Site Control Unit

Software/Firmware

pdficon large Firmware Upgrade Instructions
softwareicon Current Firmware

Parts & Accessories

FPA65R-BU4DB-K Four foot (1.2 m) antenna with 65° azimuth beamwidth, 4.3-10 female connectors, 4 factory installed BSA-RET400 RET actuators (Type 17 internal) and MBK-15 mounting bracket
MBK-02 Mounting bracket kit (top and bottom) with 0° to 10° mechanical tilt adjustment
MBK-15 Mounting Kit with fixed 0° mechanical tilt
BSA-RET400 Type 17 Internal Remote Electrical Tilt System (RET)
AISGC-M-F-xFT AISGC-M-F-10FT 10 Ft (3 m) Male/Female RRU to Antenna AISG cable

Standards & Compliance

Safety EN 60950-1, UL 60950-1
Emission EN 55022
Immunity EN 55024
Environmental IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-5, IEC 60068-2-6, IEC-60068-2-11, IEC 60068-2-14, IEC 60068-2-18, IEC 60068-2-27, IEC 60068-2-29, IEC 60068-02-30, IEC 60068-2-52, IEC 60068-2-64, GR-63-CORE 4.3.1, EN 60529, IP 24

Certifications

Antenna Interface Standards Group (AISG), Federal Communication Commission (FCC) Part 15 Class B, CE, CSA US, ISO 9001
 
ISO9001Logo RoHS CE logo AISGLogo 3GPPLogo
  Footer
              
     
     
       
 

CCILogoType

89 Leuning Street

South Hackensack, NJ 07606

+1 (201) 342-3338

+1 (201) 342-3339 fax