Multi-Port Antennas

CCI Portal Login

CCI Customer Portal

In the Americas
   
 
 
 
Sales  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Customer Service  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Technical Support  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
 
      Diplexed Multi-Band Antenna DMP65R-BU4D
                
       
       
         
  PI DMP65RBU4DA ISO FRONT PI DMP65RBU4DA ISO REAR  
  • Four foot (1.2 m) internally multiplexed MultiBand antenna, including eight external RF ports (12 RF ports internal), with a 65° azimuth beamwidth covering 698-896 MHz and 1695-2400 MHz frequencies
  • Four wide high band ports covering 1695-2400 MHz and four wide low band ports covering 698-896 MHz in a single antenna enclosure
  • Innovative Multiplexed/RET Control configuration, supporting Dual Band Radio Configurations (B12/B5 and B29/B5). The antenna provides Dual 4T4R (4x4 MIMO) capability, while providing independent RET control, an Industry First
  • Innovative Low and High Band Array configuration allows for 4T4R (4x4 MIMO) on Low Band and 4T4R (4x4 MIMO) High Band Arrays, using full length arrays (non stacked), all in a 20.7” (525 mm) width enclosure, an Industry First
  • Industry leading antenna topology and RET shielding techniques drastically mitigate PIM propagation from B12/B14/B29 operations, allowing for superior Network performance
  • Full Spectrum Compliance for PCS, AWS-3 and WCS frequencies and 700/850 MHz Dual Band Radio Configurations
  • LTE Optimized FBR and SPR performance, providing for an efficient use of valuable radio capacity
  • LTE Optimized Boresight and Sector XPD and USL performance, essential for LTE Performance
  • Exceeds minimum PIM performance requirements
  • Equipped with new 4.3-10 connector, which is 40% smaller than traditional 7/16 DIN connector
  • Ordering options for External RET Controllers (Type 1) or Internally Integrated RET Controllers (Type 17)

Overview

 

The CCI internally multiplexed MultiBand array is an eight port (12 RF ports internal) antenna, with four wide band ports covering 1695-2400 MHz and four low band ports covering 698-896 MHz. The antenna provides the capability to deploy 4T4R (4x4 MIMO) in the high band, with separate RET control. The antenna also provides the capability to provide independent RET control for 700/850 MHz Dual Band Radio Configurations, while maintaining 4T4R (4x4 MIMO) across the low band ports.

CCI antennas are designed and produced to ISO 9001 certification standards for reliability and quality in our state-of-the-art manufacturing facilities.

Applications

 
  • 4×4 MIMO for the High Band and 4X4 MIMO Low Band ports
  • Ready for Network Standardization on 4.3-10 DIN connectors
  • With CCI’s multiband antennas, wireless providers can connect multiple platforms to a single antenna, reducing tower load, lease expense, deployment time and installation costs

Electrical

     
Ports 4 × Low Band Ports for 698-896 MHz
Frequency Range 698-798 MHz 824-896 MHz
Gain1 12.7 dBi 13.0 dBi
Gain (Average)2 11.5 dBi 12.3 dBi
Azimuth Beamwidth (-3dB) 75° 67°
Elevation Beamwidth (-3dB) 19.9° 17.9°
Electrical Downtilt 2° to 16° 2° to 16°
Elevation Sidelobes (1st Upper) <-16 dB <-16 dB
Front-to-Back Ratio @180° > 32 dB > 35 dB
Front-to-Back Ratio ±20° > 28 dB > 32 dB
Cross-Polar Discrimination at Peak > 25 dB > 25 dB
Cross-Polar Discrimination at Sector2 10.7 dB 11.1 dB
Cross-Polar Port-to-Port Isolation > 25 dB > 25 dB
Voltage Standing Wave Ratio (VSWR) < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -153 dBc ≤ -153 dBc
Input Power Continuous Wave (CW) 500 watts 500 watts
Polarization Dual Linear 45° Dual Linear 45°
Input Impedance 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground
1Peak gain across sub-bands.
2Electrical specifications follow document "Recommendation on Base Station Antenna Standards" (BASTA) V9.6.
         
Ports 4 × High Band Ports for 1695-2400 MHz
Frequency Range 1695-1880 MHz 1850-1990 MHz 1920-2180 MHz 2300-2400 MHz
Gain1 16.4 dBi 16.4 dBi 16.9 dBi 17.2 dBi
Gain (Average)2 15.3 dBi 15.9 dBi 16.1 dBi 16.6 dBi
Azimuth Beamwidth (-3dB) 71° 69° 69° 57°
Elevation Beamwidth (-3dB) 8.2° 7.3° 6.8° 5.9°
Electrical Downtilt 2° to 10° 2° to 10° 2° to 10° 2° to 10°
Elevation Sidelobes (1st Upper) <-15 dB <-16 dB <-16 dB <-15 dB
Front-to-Back Ratio @180° > 35 dB > 35 dB > 35 dB > 35 dB
Front-to-Back Ratio ±20° > 30 dB > 30 dB > 30 dB > 30 dB
Cross-Polar Discrimination at Peak > 18 dB > 17 dB > 18 dB > 19 dB
Cross-Polar Discrimination at Sector2 9.6 dB 7.4 dB 7.7 dB 9.3 dB
Cross-Polar Port-to-Port Isolation > 25 dB > 25 dB > 25 dB > 25 dB
Voltage Standing Wave Ratio (VSWR) < 1.5:1 < 1.5:1 < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -153 dBc ≤ -153 dBc ≤ -153 dBc ≤ -153 dBc
Input Power Continuous Wave (CW) 300 watts 300 watts 300 watts 300 watts
Polarization Dual Linear 45° Dual Linear 45° Dual Linear 45° Dual Linear 45°
Input Impedance 50 ohms 50 ohms 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground DC Ground DC Ground
1Peak gain across sub-bands.
2Electrical specifications follow document "Recommendation on Base Station Antenna Standards" (BASTA) V9.6.

Mechanical

Dimensions (L×W×D) 48.0×20.7×7.7 in (1220×525×197 mm)
Survival Wind Speed > 150 mph (> 241 kph)
Front Wind Load 212 lbs (943 N) @ 100 mph (161 kph)
Side Wind Load 90 lbs (402 N) @ 100 mph (161 kph)
Equivalent Flat Plate Area 8.3 ft2 (0.8 m2)
Weight * 67.9 lbs (30.8 kg)
Connector 8 × 4.3-10 female
Mounting Pole 2 to 5 in (5 to 12 cm)
* Weight excludes mounting
Bottom View  
   PI DMP65RBU4DA bottom label new
Connector Spacing  
  PI DMP65RBU4DA Connector Spacing
RET to Element Configuration  DMP65R-BU4DA Element and RET configuration (Type 1 External RET)
   PI DMP65RBU4DA RET Element Jan2020

Typical Antenna Patterns

  For detailed information on additional antenna patterns, contact customer support at
  DMP65RBU4D AP 698 AZEL9 DMP65RBU4D AP 840 AZEL9
  698 MHz Azimuth with Elevation 9° 840 MHz Azimuth with Elevation 9°
  DMP65RBU4D AP 1780 AZEL6 DMP65RBU4D AP 2155 AZEL6
  1780 MHz Azimuth with Elevation 6° 2155 MHz Azimuth with Elevation 6°
MBK-15   MBK-15 Mounting Kit with fixed 0° tilt
MBK-02   MBK-02 Mounting Kit with 0° - 10° mechanical tilt
DM-01   DM-01 Dual Mount Mast Bracket Kit
BSA-RET200   Type 1 External Remote Electrical Tilt System (RET)
BSA-RET400   Type 17 Internal Remote Electrical Tilt System (RET)
HPA-CBK-AG-RRU   AISG Cable set for three RET antenna with Type 1 RET
HPA-CBK-RA-AG-RRU   AISG Right Angle Cable set for three RET antenna with Type 1 RET
SCU-AISG-P   Portable AISG 2.0 Site Control Unit

Software/Firmware

pdficon large Firmware Upgrade Instructions
 softwareicon Current Firmware

Parts & Accessories

DMP65R-BU4DA-K Four foot (1.2 m) antenna with 65° azimuth beamwidth, 4.3-10 female connectors, 3 factory installed BSA-RET200 RET actuators (Type 1 external) and MBK-15 mounting bracket
DMP65R-BU4DB-K Four foot (1.2 m) antenna with 65° azimuth beamwidth, 4.3-10 female connectors, 3 factory installed BSA-RET400 RET actuators (Type 17 internal) and MBK-15 mounting bracket
MBK-15 Mounting bracket kit (top and bottom) with fixed 0° mechanical tilt
MBK-02 Mounting bracket kit (top and bottom) with  0° to 10° mechanical tilt
DM-01 Dual mount mast bracket for side by side antenna mounting
BSA-RET200 Type 1 External Remote Electrical Tilt System (RET)
BSA-RET400 Type 17 Internal Remote Electrical Tilt System (RET)
HPA-CBK-AG-RRU Antenna with 3 Type 1 RET to RRU AISG cable kit
HPA-CBK-RA-AG-RRU
Antenna with 3 Type 1 RET to RRU AISG right angle cable kit 

Standards & Compliance

Safety EN 60950-1, UL 60950-1
Emission EN 55022
Immunity EN 55024
Environmental IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-5, IEC 60068-2-6, IEC-60068-2-11, IEC 60068-2-14, IEC 60068-2-18, IEC 60068-2-27, IEC 60068-2-29, IEC 60068-02-30, IEC 60068-2-52, IEC 60068-2-64, GR-63-CORE 4.3.1, EN 60529, IP 24

Certifications

Antenna Interface Standards Group (AISG), Federal Communication Commission (FCC) Part 15 Class B, CE, CSA US, ISO 9001
 
ISO9001Logo RoHS CE logo AISGLogo 3GPPLogo
  Footer
              
     
     
       
 

CCILogoType

89 Leuning Street

South Hackensack, NJ 07606

+1 (201) 342-3338

+1 (201) 342-3339 fax